Multiple outlining teeth bore clean, flat-bottom holes without chipping or splintering your surface—even when cutting across the grain. Also known as multispur bits.

An open spiral-flute design clears chips quickly, so these bits can bore smooth, deep holes through construction lumber, railroad ties, and utility poles. Also known as pole or ship auger bits.

Cut a variety of hole sizes with one bit—slide the blade to the desired cutting diameter marked on the bit and then tighten the screw. Use in a drill press; they are not recommended for use with handheld drills.

The screw point draws the bit in, quickly boring holes without applying pressure.

Unlike traditional wire-installing drill bits, you do not need to strip the end of the wire when using one of these bits. After drilling, insert the wire into the bit's hollow shaft and pull through the hole.

Use these guides to position flexible-shaft drill bits.

Three sharp points allow these bits to drill accurate straight and overlapping holes, even across the grain. Also known as brad-point bits.

Bore smooth-finish, flat bottom holes in soft wood, veneer, and laminates. Also known as Forstner bits.

For jobbers’ and brad-point drill bits.

These counterbores are attached to a drill bit for drilling and counterboring in a single step.