The clamping arm slides freely along the bar for quick, one handed positioning. Tighten the screw onto a workpiece and the arm locks in place.

For the most demanding jobs, these clamps have almost five times the capacity of standard fast-action bar clamps.

Pull the lever to slide the clamping arm along the bar; release to lock in place.

Place the arms on a pipe that is threaded at one end and at least 12" long to create your own bar clamp.

Press the trigger to slide the clamping arm along the bar. Release the trigger and squeeze the pistol-grip handle to lock the clamp in place.

Press the trigger to slide the clamping arm along the bar. Release the trigger and squeeze the pistol-grip handle to lock the clamp in place.

Clamp much farther in from the edge of the workpiece than with standard bar clamps.

Attach to your bar clamp to hold material on three sides.

Turn the handle to tighten these multipurpose tools for strong clamping in nearly any application.

These clamps have twice the capacity of standard C-clamps.

These clamps are made of stainless steel for excellent corrosion resistance.

Made entirely of fiberglass, these clamps won’t transmit electricity and are chemical resistant. They're often used around electrical equipment as well as in plating and anodizing applications.

A bright finish makes these clamps easy to see.

With no handle or protruding screw, these clamps can fit into tight spaces.

The jaws move in unison to apply even pressure and prevent twisting.

Hold the workpiece down against a bench or table.

Hold workpieces of different thicknesses without adjustment.

Push the lever to lock the handle and prevent accidental opening.

Push the lever to lock the handle and prevent accidental opening.

Hold workpieces of slightly different thicknesses with one clamp. These clamps automatically adjust to compensate for imperfections or small inconsistencies on the material’s surface.

Push the lever to lock the handle and prevent accidental opening.

Two sets of mounting holes allow mounting on the bottom or side.

Weld these clamps to the side of an object or drill your own holes in the mounting plate and bolt into place.

Replace worn screws or customize your clamps.

Turn the knob to adjust the opening size.

For repetitive clamping, turn the holding screw to adjust the opening size one time, and then use the handles to secure and release workpieces.

These clamps meet DIN VDE 0680-1 for protection against accidental contact with live electrical circuits.

Press the lever to lock the clamp onto material.

Hold large workpieces with a standard-size clamp. Slide the jaws to adjust the opening size.

Attached to an arm you can flex into position, these clamps hold objects such as a flashlight, tool, or instructions.

Set includes 12 clamps and the installation pliers required for positioning and removal.

Hold workpieces of different thicknesses without adjustment.

Smaller than standard push toggle clamps, these are often used for electronics and small fixturing applications.

Push or pull the plunger to hold your workpiece from the side.

Secure your workpiece from the side by fully extending the plunger, and push a lever to lock the handle in place.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

Hold workpieces at a 90° angle.

The clamping surfaces pivot individually to secure workpieces of different thicknesses at any angle from 5° to 180°.

Clamp up to three workpieces at 90° angles.

Each jaw can be positioned at an angle to hold round, angled, and odd-shaped material.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Push the lever to lock the handle and prevent accidental opening.

Screw these clamps directly into a tapped hole in a fixture.