Shield against extreme heat with these flexible ceramic strips. They are often used to insulate hose, cables, and process piping.

This common insulation material is typically used on hot and cold water lines and in process piping.

Rigid and flame resistant, these insulation tubes are typically used in process piping and mechanical systems.

Superior in strength and durability, these thin strips insulate as well as protect personnel from accidental contact with hot pipes. Use for exhaust, hot water, and process pipes.

Lightweight and super thin, these fiber-reinforced silica aerogel sheets and strips flex into tight spaces other insulation can't. Use on process piping and in power-generating applications.

Reduce the risk of burns from accidental contact with hot pipes under your sink. These molded, flexible pipe covers are ADA compliant when properly installed.

These rigid, lightweight melamine foam tubes are wrapped in an ISO Class 5 (Class 100) clean room jacket that is suitable for sanitary and washdown applications. They’re typically used on cold and hot water piping and with refrigeration systems.

This very rigid insulation offers the lowest heat-flow rate of our pipe insulation and restricts absorption of water, air, and gas. It is typically used in process piping and chiller plants and performs best in applications below 50° F.

Wrap pipes, tubing, and fittings to prevent condensation from forming. These strips are for use on copper, iron, and steel.

Guard insulation from heavy impact and chemical exposure. This metal jacketing is corrosion resistant and often used outdoors.

Protect and repair insulation with this cotton fiber and resin mesh.

Made of flexible composite paper, these sheets won't shrink or lose shape in the high temperatures of air furnaces and hot water tanks.

The most common of our flexible high-temperature sheets, these are used to insulate furnaces.

The perforated vinyl facing allows moisture to evaporate and resists cracking and fading. These flexible sheets are good for insulating large enclosures.

Made of high-strength calcium silicate, these durable sheets withstand high temperatures and are often used in power-generating applications.

Wet these rigid sheets and they become formable. They can be molded multiple times until exposed to heat, which causes them to become rigid again.

These durable sheets resist compression and are often used in oven and power-generating applications.

Typically used in ovens and furnaces, these are the most efficient of our rigid high-temperature insulation sheets. Please note that they require special care when installing since the crumbly material is difficult to work with and will crack easily. Sheets lose strength over time and are intended to be installed behind another facing or insulation material.

Designed for fluctuating, high-temperature applications, these semi-rigid sheets are typically used in furnaces and fire protection applications. They experience very little shrinkage at high temperatures, but the brittle material can be somewhat difficult to work with.

Stronger than standard firebricks but with lower insulation capabilities, these withstand heavy abrasion on the floors and sides of furnaces. Also known as hard firebricks.

Set and repair cast iron and steel furnaces, heaters, stoves, and boilers with this ready-to-use cement. It experiences minimal shrinkage for a permanent smokeproof and gasproof joint. Apply with a trowel or a spatula.

Typically used as duct wrap, these flexible sheets consist of polyethylene bubbles covered with aluminum polyester foil that prevent 96% of heat from radiating into or away from duct. Use on rectangular and round ductwork.

Insulate rectangular ductwork.

Also known as batts, these fiberglass sheets and strips are used to insulate walls, ceilings, and floors.

This two-part expanding foam insulation meets ASTM E84 20/400 for flame and smoke and covers large areas.

Attach these hanger studs to a flat surface, then press your insulation sheets onto the spikes and secure with a washer.

Use these sheets in operating temperatures below 32° F, such as cold-storage applications.