Clear All
    Collet Type
    Collet Type
    100-TG
    For Collet Type
    For Collet Type
    100-TG
    System of Measurement
    System of Measurement
    Inch
    For Holding
    For Holding
    Collets
    Drill Bits
    End Mills
    Reamers
    For Use With
    For Use With
    Milling Machines
    Face Type
    Face Type
    Round
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Overall Length
    Overall Length
    2.386"
    Material
    Material
    Steel
    Shank Type
    Shank Type
    CAT 40 Taper
    Approximate Diameter Compression
    Approximate Diameter
    Compression
    1/64"
    Maximum Body Diameter
    Maximum Body Diameter
    1.278"
    Projection
    Projection
    2 3/4"
    3 1/2"
    Mounting Location
    Mounting Location
    Bench Top
    Mounting Slot Width
    Mounting Slot Width
    1/4"
    Number of Mounting Slots
    Number of Mounting Slots
    2
    For Number of Collets
    For Number of Collets
    27
    Mounting Slot Length
    Mounting Slot Length
    1 1/16"
    Overall Depth
    Overall Depth
    17"
    Overall Height
    Overall Height
    2"
    Overall Width
    Overall Width
    9 1/8"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    17 Products