Use these controls with motors that run forward and backward, such as motors for conveyor belts.

Use these controls with motors that run forward and backward, such as motors for conveyor belts.

Mount these controls to DIN rail inside a control panel.

Rated NEMA 4, these controls are protected from washdowns.

Control the speed of low-voltage permanent-magnet DC motors.

With a shallower depth than most other starters, these fit in narrow spaces.

Sized to fit in tight spaces, these starters have a shorter height and narrower depth than most other starters.

Housed in a durable steel enclosure.

Rated NEMA 4X, these enclosed starters are protected from corrosion and washdowns.

Operated by hand, these starters are more compact than electrically actuated motor starters; use them when multiple motor circuits are housed in one panel.

Combine a switch and a thermal overload element to build a starter that can handle high-current-rated motors. Also known as a NEMA starter.

These switches are housed in a protective enclosure.

These switches are rated NEMA 3R for protection from falling water and light splashing.

Use these switches with motors that run forward and backward, such as motors for conveyor belts.

Use the mounting holes to attach monitors to a flat surface.

For use with equipment that cycles on and off, these relays meet UL 508 for air conditioning and heating. Also known as definite-purpose contactors.

With no moving parts, these solid state relays have an extended service life. Mount them directly to DIN rail.

Thinner than other spade-terminal relays, these fit in tight spaces.

Mount relays to a flat surface using the slot on the flange.

These sealed relays meet UL Class I, Division 2, Groups A, B, C, and D for use in hazardous locations.

The built-in enclosure protects contacts from dust and dirt.

These relays switch through a series of different circuit configurations every time they receive an input voltage. Also known as step relays.

Prevent voltage spikes from damaging your programmable logic controller or other sensitive control device. Thinner than other signal relays, these fit in tight spaces.

Also known as power relays, these relays are rated for 1 horsepower or 30 amps and are suitable for compressors, blowers, and heaters.

Tell your stepper motor how far and fast to go by adding a controller and driver to your system.

Instead of a shaft, these stepper motors have a lead screw that converts rotational motion to linear motion.

Also known as hysteresis clutches, these couplings use magnetic force to brake, control tension, and prevent torque overload. They have few moving parts, so they last longer than mechanical couplings.

Adjust your system's torque limit by hand.

Use these with an overload sensor in an automated system to instantly disconnect power and prevent damage. Couplings also accelerate loads from zero to full speed in less than three milliseconds when the power is turned on.

Adjust your system's torque limit by hand.

Convert output drives from female to male.