Alumina ceramics withstand higher temperatures than any other ceramic and are highly chemical resistant. Powder is often used in casting processes. Add it to slurries to create custom parts and tools such as crucibles, cutting tools, and laboratory ware.

Often used to create prototype components, these ceramic sheets come semi-fired so they can be machined using conventional metalworking tools.

Each of these sets comes with four differently shaped stones.

Apply a layer of compound by holding one of these bars against a revolving buffing wheel.

The premium abrasive stays sharp longer. Holes in the disc let you see the surface you’re sanding.

Fit these discs over your tool’s arbor to sand stainless steel and hard metals.

Create consistent finishes on stainless steel, titanium, steel, iron, and nickel.

Used for heavy cleaning and stripping, these discs have an abrasive-embedded nylon mesh construction that gives you more control over sanding pressure.

The flaps wrap around the outer edge of these discs to sand welds at right angles.

A coating prevents dust and debris from building up on the abrasive surface.

With more flaps than standard discs, these last 30-40% longer.

Set at an angle and widely spaced, the flaps reach into corners.

A different grit on each side enables multistep sharpening with one stone.

A more durable abrasive allows these wheels to remove more material and last longer than Norton General Purpose Grinding Wheels. They are also known as Type 1 wheels and straight wheels.

The most common of our flexible high-temperature sheets, these are used to insulate furnaces.

Designed for fluctuating, high-temperature applications, these semi-rigid sheets are typically used in furnaces and fire protection applications. They experience very little shrinkage at high temperatures, but the brittle material can be somewhat difficult to work with.

A ceramic alumina abrasive cuts through stainless steel.

Made of a combination of ceramic alumina and zirconia alumina, these wheels last up to ten times longer than standard cutoff wheels when cutting hard metal such as Inconel, Hastelloy, and tool steel.

These high-density ceramic oxide wheels have two layers of fiberglass mesh reinforcement and last up to twice as long as long-life cutoff wheels when cutting aluminum, iron, stainless steel, and steel.