The most widely used aluminum, 6061 is fabricated into everything from pipe fittings and containers to automotive and aerospace parts. It is strong and corrosion resistant, plus it's easy to machine and weld.

The thickness is oversized to allow for finishing to exact requirements.

One side of these sheets and bars is polished to either a brushed finish or a mirror-like finish.

More corrosion resistant and easier to form than multipurpose 6061 aluminum, 6063 is primarily used for exterior railings, decorative trim, and door frames.

Known for being one of the easiest types of aluminum to weld, 5052 is also recognized for its ability to resist salt water. It's widely used for the bodies of boats, buses, trucks, and trailers, as well as for chemical drums.

3000 series aluminum stands up to outdoor use, as well as exposure to chemicals. It offers a good combination of strength, formability, and weldability. It's often used for storage tanks, heat exchangers, garage doors, and general sheet metal work.

The textured surface on these sheets increases rigidity and hides fingerprints and dents.

A honeycomb core is bonded between two aluminum sheets for rigidity.

Made of 1000 series aluminum which is 99% pure, this aluminum offers superior formability, corrosion resistance, and electrical conductivity. It's frequently fabricated into raceways, decorative trim, and other parts where strength and hardness are not required.

Use this foil as a blanket to disperse heat evenly in high-vacuum systems, as well as in clean rooms and other controlled environments where dust and oil could jeopardize a system.

5086 aluminum is used on ships, oil rigs, tanks, and pressure vessels because of its excellent saltwater resistance and formability.

Also known as armor plate, these 5083 aluminum sheets are hardened to an H131 temper for increased strength and impact resistance over standard 5083 sheets.

While 2024 aluminum was initially designed for structural components in aircraft, it's now widely used when a high strength-to-weight ratio is needed, such as for gears, shafts, and fasteners. It offers similar performance to 7075 aluminum, but it’s not as strong.

Also known as flat stock, these sheets and bars are precision ground on the top and bottom.

Choose between sheets and bars that are precision ground on all six sides or just on the top and bottom.

Substitute 7050 aluminum for 7075 in structural applications when high stress-corrosion resistance is required. It is the same material that's used for bulkheads and fuselage frames.

MIC6 is cast from a high-strength 7000-series aluminum, then stress relieved to maintain dimensional stability during high-speed machining.

A layer of soft LDPE is sandwiched between two thin layers of aluminum for strength and rigidity.

Cut this stock into custom shapes to fit your application.

A durable acrylic adhesive keeps this shim stock from sliding out of place. Cut it into custom shapes to fit your application.

This shim stock is color coded by thickness for easy identification. Cut it into custom shapes to fit your application.

Create a custom shim to fit your application.

These sheets have good corrosion resistance, weldability, and formability. Aluminum is lightweight.

Harder and stronger than our other aluminum perforated sheets, these sheets have greater wear resistance.

Guard insulation from heavy impact and chemical exposure. This metal jacketing is corrosion resistant and often used outdoors.

Wrap pipes, tubing, and fittings to prevent condensation from forming. These strips are for use on copper, iron, and steel.

Also known as fire wrap, these flame-resistant sheets meet ASTM E84 0/0 for flame and smoke and create a fire barrier around rectangular and round ductwork. They are often used to wrap kitchen grease exhaust ducts and air ducts.