Clamp these anchors onto I-beams—they give you a secure place to clip your fall-arrest lanyard without damaging the beam surface. Plus, they’re reusable and don’t require tools to install and remove. When used together with a harness and lanyard, these anchors help you meet OSHA and ANSI safety standards.

Stationary anchors mount to horizontal and vertical I-beams. They’re great when working in a single location.

Mobile anchors move with you, so you’re free to work along the length of the beam. Those with bronze inserts glide smoothly for easy movement. Those with roller bearings are best when you need to move back and forth frequently. They roll along the beam with less effort than with other mobile anchors.

Connect fall-arrest lanyards to these anchor points. You'll want to install these into an approved, stable surface that is strong enough to support someone. When used together with a lanyard and a harness, they help you meet OSHA and ANSI safety standards.

Quick-install push-in anchors mount overhead into vertical holes in steel without requiring any tools. Pull the collar back to retract the spring-loaded blade and slide the anchor into the hole. When you release, the blade rotates to lock the anchor in place. When you’re done, pull the collar back to remove the anchor.

Weld-on anchors swivel 360°, so your lanyard turns smoothly with you as you move.

Stainless steel anchors resist corrosion, so they stand up to outdoor elements and in spaces where moisture and grime could weaken the anchor.

A secure hold that won’t damage your mounting surface—these anchors clamp onto stable structures such as half-walls to give you a place to clip your fall-arrest lanyard. Even though they clamp, they grip firmly with set screws and a locking pin. Made of powder-coated steel, they’re tough enough to stand up to frequent use, even outdoors. Protective pads on the clamp arm and set screws keep them from scratching your surface. When used with a harness and lanyard, these anchors help you meet OSHA and ANSI safety standards.

Anchor your fall-arrest lanyard to overhead grating, girders, and other stable structures. These anchors give you a secure, stable way to clip in without being permanent. Slip these anchors through a hole and the plate on the end catches firmly. When the job’s done, pull the anchor out and use it again. Polyurethane tubing near the plate protects the anchor from abrasion. When used together with a lanyard and harness, these anchors help you meet OSHA and ANSI safety standards.