The handle locks in a horizontal position for more clearance above the clamp than standard hold-down toggle clamps.

Reduce the chance of getting pinched when unclamping. These clamps have more space between the handle and the arm than other low-profile toggle clamps.

Hold workpieces of different thicknesses without adjustment.

A nonreflective black oxide finish prevents glare that can interfere with machine vision systems.

Hold workpieces of slightly different thicknesses with one clamp. These clamps automatically adjust to compensate for imperfections or small inconsistencies on the material’s surface.

Push the lever to lock the handle and prevent accidental opening.

The mounting base secures these clamps to a rail or bar.

Bolt to the side of an object. Often used to clamp lids and covers on containers.

Two sets of mounting holes allow mounting on the bottom or side.

These clamps have mounting holes on the bottom.

A removable, heavy duty steel base plate provides a flat, durable clamping surface. Carry it where needed or mount the base plate to your workbench.

Push or pull the plunger to hold your workpiece from the side.

Hold workpieces of different thicknesses without adjustment.

Smaller than standard push toggle clamps, these are often used for electronics and small fixturing applications.

Pull the handle backward to push the plunger forward. These clamps secure when the plunger is fully extended to hold your workpiece from the side.

Moving parts are protected by a metal cover when the clamp is engaged to prevent dirt and dust from clogging the clamp.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

Drill a hole to mount these clamps through a surface and secure the mounting flange with screws. The plunger can be locked at any position along its travel.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Push the lever to lock the handle and prevent accidental opening.

With five times the capacity of standard corner clamps, these secure two workpieces at a 90° angle.

Switch the magnets on these clamps on and off for easy placement and removal of your workpiece.

Sized for small parts and tight spaces, these clamps have a pivoting pad at each end to hold workpieces at any angle up to 180°.

Two clamps connected by a pivoting arm hold workpieces at nearly any angle.

Mount using the holes in the base.

Quickly install and remove the clamp-on base from a benchtop.

Made of 304 stainless steel to stand up to washdown environments, such as food and beverage production, these are the most corrosion-resistant vises we offer.

Two vise heads tilt and rotate 360°, locking in place to hold work at any angle.

For large workpieces, these vises open three times as wide as standard tilting-head vises. Tilt and lock the head to position work at an angle.

Hold tiny workpieces in these compact vises.

The movable jaw can be repositioned to extend the jaw opening. Pull out the entire sliding section and insert it on the opposite side of the vise.

Designed for outdoor use, these vises have a finish that resists corrosion.