Search Results
    System of Measurement
    System of Measurement
    Inch
    Metric
    Cut Direction
    Cut Direction
    Right HandNeutral
    Left Hand
    Shank Type
    Shank Type
    RoundSquare
    Material
    Material
    Carbide
    Steel
    For Insert Shape
    For Insert Shape
    DiamondTriangle
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Material Grade
    Material Grade
    Micrograin
    C6
    C2
    End Cutting Edge Angle
    End Cutting Edge Angle
    default
    38°
    52°
    Side Cutting Edge Angle
    Side Cutting Edge Angle
    default
    30°
    45°
    -5°
    End Relief Angle
    End Relief Angle
    default
    10°
    Back Rake Angle
    Back Rake Angle
    default
    12°
    Side Rake Angle
    Side Rake Angle
    default
    Insert Shape
    Insert Shape
    TriangleDiamond
    For Insert Inscribed Circle Diameter (IC)
    For Insert Inscribed
    Circle Diameter (IC)
    default
    5/32"
    0.160"
    1/4"
    3/8"
    1/2"
    Insert Holding Method
    Insert Holding Method
    Torx Screw
    Hex Screw
    Clamp with Lock Pin Screw
    Side Relief Angle
    Side Relief Angle
    default
    10°
    13°
    15°
    20°
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    495 Products