Multiple outlining teeth bore clean, flat-bottom holes without chipping or splintering your surface—even when cutting across the grain. Also known as multispur bits.

Cut a variety of hole sizes with one bit—slide the blade to the desired cutting diameter marked on the bit and then tighten the screw. Use in a drill press; they are not recommended for use with handheld drills.

The screw point draws the bit in, quickly boring holes without applying pressure.

These bits are cut to match a wood screw’s thread and diameter, resulting in a perfect fit for a screw. They produce clean edges when cutting soft and hard wood.

Drill holes up to 1 1/2" in diameter.

With better heat and wear resistance than high-speed steel, cobalt steel bits can run up to 25% faster and have a longer tool life.

The built-in guide has a beveled tip that fits into countersunk holes in hardware, such as hinges and latches, to center the bit.

The shaft is made of spring steel instead of hardened steel, so it flexes while drilling, allowing you to drill inside walls or between floors.

The screw point draws the bit in, quickly boring holes without applying pressure.

Also known as spade bits, these have a centering point and two cutting edges for boring holes in hard and soft wood.

Steps with progressively larger diameters let you drill a range of sizes with one bit. Also known as step drills.

Drill and finish holes in a single pass with these dual-purpose tools.

Drill and ream holes for tapered pins with the same tool. They are for use in drill presses, turret lathes, screw machines, and other machine tools.

Often used with screw holes in misaligned sheets or layers of material.

Also known as step drill bits. The 82° countersink angle is compatible with the profile of flat- and oval-head inch screws.

The long steel shank on these tools can reach farther inside the workpiece than standard boring tools.

Insert the square shank of these tools into the slot of a boring tool holder and use them to enlarge existing holes to precise diameters.

The diamond tip on these tools offers superior cutting performance on nonferrous and nonmetallic materials, such as aluminum, copper, fiberglass, and plastic.

An extra-long shank provides additional reach.

The long steel shank on these tools can reach farther inside the workpiece than standard boring tools.

Constructed of a carbide tip brazed onto a ground steel shank, these tools are more wear resistant than high-speed steel tools.

Insert boring tools into a 45° or 90° slot at either end of the holder.

Reduce tooling setup time—install the holder once and alternate between applications by switching out the bit.

Pair one of these inserts with a compatible boring carbide insert holder with coolant hole.

Use these tools to enlarge existing holes to precise diameters. They come with an insert installed. When one edge of the insert dulls, rotate it to use a sharp edge.

Contour the interior wall of a hollow workpiece when you pair a holder with a compatible insert.

These sets have five indexable turning tools with carbide inserts and a wood storage stand. When one edge of a tool's insert dulls, rotate it to use a sharp edge.

Increase the diameter of boring bars, drill bits, and other shank-style cutting tools to securely fit CNC lathe tool blocks.