Floor locks bolt or weld to the underside of your equipment and have a spring-loaded base with a nonskid floor pad to keep equipment stationary.

Set these floor locks to the height you need to compensate for uneven and sloped floors.

Remove the handle to wind these winches with a power drill and move loads more gradually than with other winches. The one-piece machined gears stand up to daily use.

Tackle frequent lifting jobs with these rugged winches—their one-piece machined gears stand up to daily use.

Move loads more gradually than with other winches. These take longer to wind but require less effort. Their one-piece machined gears stand up to daily use.

An automatic brake holds the load, even when power is lost.

Because these winches run on compressed air, they give you longer operating times than electric winches.

Also known as electric hysteresis brakes, these couplings use magnetic force to create drag to slow or stop the motion of your drive system.

Also known as hysteresis clutches, these couplings use magnetic force to brake, control tension, and prevent torque overload. They have a shaft on one end for connecting to other components.

Adjust your system's torque limit by hand.

Often used in automated systems, these couplings are air actuated so you can adjust the torque during operation.

If they exceed maximum torque, these couplings disengage, sound an alarm, and then automatically re-engage once the overtorque condition is eliminated.

Also known as semimetallic woven strips, these strips have a brass wire woven into the material to increase strength and improve heat dissipation.

Also known as nonmetallic molded strips.

Shape sheet metal using your bench vise as a sturdy base.

Position the movable forming dies, also known as fingers, to make boxes, trays, and pans in different widths.

Make bends up to 135° in metal sheets. Benders have a clearance of 4" for insertion and removal of large workpieces such as vehicle panels and duct work.

Save space in your shop by cutting, bending, and curving sheet metal with a single machine. Also known as shear brake rolls.

Control these flexible, ready-to-use cables with the attached trigger-style spring-return lever. Weave them around obstructions to operate valves, throttle controls, and HVAC damper controls from a distance.

Use these cables for high-precision motion control. Tighten the locknut to secure your setting in applications where severe vibration is a concern. Flexible for weaving around obstructions, these ready-to-use cables operate valves, throttle controls, and HVAC damper controls from a distance.

A splined core limits contact points on the cable’s liner, so the core slides back and forth smoothly and keeps the cable from twisting. Pair these cables with a knob or lever to operate valves, throttle controls, and HVAC damper controls from a distance. They're flexible for weaving around obstructions.

Well-suited for damp environments, these control cables have stainless steel fittings for excellent corrosion resistance. Pair them with a knob or lever to operate valves, throttle controls, and HVAC damper controls from a distance. They're flexible for weaving around obstructions.

Install these rotary speed limiters at the hinges of small lids, doors, and access panels for smooth, quiet motion.

With output shaft openings on both sides, these speed reducers adapt to fit multiple configurations. Mount to a NEMA 56C motor.

Convert output drives from female to male.

Cut shaft speed and increase torque while transmitting motion at a 90° angle in food, pharmaceutical, and other sanitary environments.

The input and output shafts are positioned at the same height, so these speed reducers take up less than half the vertical space as our standard right-angle speed reducers.

Pair these speed reducers with NEMA stepper and servo motors. Helical gears provide exact positioning and smoother travel than our other speed reducers.

Press these switches with your foot for convenient, hands-free operation.

Apply pressure from any direction to actuate these switches.

Mate with a T-slotted rail to add linear motion to your assembly.

Fasten loads on the side of these carriages and add linear motion to a T-slot assembly.