Also known as vacuum breakers, these valves have vents that open when pressure drops to relieve vacuum conditions and prevent backward suction from drawing liquid into upstream piping.

Elbows are designed for intermittent flow. They discharge liquid directly and should not be installed in areas where spillage could cause damage.

Straights are often used with steam coils, heat exchangers, and space heaters.

Prevent dirty, contaminated water from backing up into your garden hose line—install these valves between a faucet and a garden hose. Also known as vacuum breakers, these valves have a built-in check valve that blocks backflow, so you can leave your hose in a utility sink full of dirty water without the water going back into the line.

When the check valve is closed, it has vents that open to release the water. This reduces pressure in the line and confirms the valve is working. Because these valves vent water, use them in environments where spilled water won’t cause a problem. This design adheres to ASSE Standard 1011 for valves with a vent.

Mount valves to faucet outlets with a set screw, and easily thread or unthread a hose while the valves stay in place.

Valves comply with Uniform Plumbing Code (UPC) and are CSA certified, so they're safe to use in sanitary plumbing systems because they prevent contamination from flowing backward into your line.

These valves are designed to be used intermittently. They've been tested under ANSI A112.1.3, which assumes the valves will not be used for more than 12 hours at a time.

Chrome-plated brass valves are more corrosion resistant than plain brass valves.

Valves with tamper-resistant set screws have a head that breaks off after tightening to prevent valve removal after installation.

Valves that meet NSF/ANSI Standard 372 are certified lead free.