Hinge leaves fit into two cutouts (mortises) to mount flush with the door and frame.

Turn a set screw to adjust the door up or down after it's hung.

Turn a set screw to adjust the door 1/8" up or down after it's hung.

Plastic hinges are a lightweight alternative to metal hinges and provide smooth, silent operation.

Turn a set screw to adjust the door 1/8" up or down after it's hung.

A grease fitting makes these hinges easy to lubricate.

Plastic hinges are a lightweight alternative to metal hinges and provide smooth, silent operation.

Plastic hinges are a lightweight alternative to metal hinges and provide smooth, silent operation.

The hinge pin is permanently attached to the frame leaf so you can quickly lift the door off the hinge without removing the pin.

Plastic hinges are a lightweight alternative to metal hinges and provide smooth, silent operation.

These hinges allow 360° of motion.

Springs in these hinges without holes automatically swing doors and gates closed behind you.

After a light push on the door, springs in these hinges swing doors and gates fully open.

Only one cutout (mortise) is needed for these hinges—the offset design allows surface mounting the door leaf and mortise mounting the frame leaf.

These hinges with holes are spring loaded—pull the handle to retract the pin and disconnect a door; release the handle and the pin snaps back.

A keeper holds the pin in a retracted position to make reconnecting doors easier than other pull-release quick-disconnect hinges.

Squeeze the hinge handles together to retract the pin and disconnect a door; release the handles and the pin snaps back.

A stop keeps these hinges open at a set angle; push past the stop to open them to 180°.

The mounting hole pattern does not follow an industry standard, which means you can work around worn mounting holes when replacing template hinges.

No need for oil or grease, these hinges are maintenance free. The mounting holes form an industry-standard half-moon shape.

Only one cutout (mortise) is needed to mount these hinges—the offset design allows surface mounting the door leaf and mortise mounting the frame leaf.

The mounting holes form an industry-standard half-moon shape.

The hinge pin is permanently attached to the frame leaf so you can quickly lift the door off the hinge without removing the pin.

Create precise outlines for hinge mortises (cutouts). Position the cutter on a wood door or frame and hit it with a hammer to imprint the outline.

Plastic bushings on these metal hinges prevent metal-to-metal contact that can release particles as hinges open and close.

Slip the hinge pins into 11/32" Dia. × 5/16" Dp. holes in a cabinet.