Reduce the chance of getting pinched when unclamping. These clamps have more space between the handle and the arm than other low-profile toggle clamps.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Mount these clamps to a bench top or other surface to keep workpieces in place.

Hold workpieces of slightly different thicknesses with one clamp. These clamps automatically adjust to compensate for imperfections or small inconsistencies on the material’s surface.

Push the lever to lock the handle and prevent accidental opening.

Push the lever to lock the handle and prevent accidental opening.

Bolt to the side of an object. Often used to clamp lids and covers on containers.

Mount these clamps below a surface.

The mounting base secures these clamps to a rail or bar.

Replace worn screws or customize your clamps.

The base fits into round or square holes on most workholding tables for clamping anywhere on the work surface.

Smaller than standard push/pull toggle clamps, these are often used for electronics and small fixturing applications.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Smaller than standard push toggle clamps, these are often used for electronics and small fixturing applications.

Moving parts are protected by a metal cover when the clamp is engaged to prevent dirt and dust from clogging the clamp.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

Secure these clamps to a rail or bar.

Drill a hole to mount these clamps through a surface and secure the mounting flange with screws. The plunger can be locked at any position along its travel.

Fit the draw arm over a latch plate and pull the handle to clamp.

Push the lever to lock the handle and prevent accidental opening.

Press the lever to lock the clamp onto material.

These clamps meet DIN VDE 0680-1 for protection against accidental contact with live electrical circuits.

Hold large workpieces with a standard-size clamp. Slide the jaws to adjust the opening size.

Extend the handle to reach the clamp into tight spaces.

The spring-loaded tips on these clamps swivel in all directions to make maximum contact with angled and uneven workpieces.