Install these socket head screws through a hole and thread on a retainer to keep secure—no special tools are required.

Install these rounded head screws through a hole and thread on a retainer to keep secure—no special tools are required.

These screws mount flush against the outer panel's surface for low-clearance applications.

The base flares out during installation, creating a backside flange in hard materials and near edges in panels up to 0.312" thick. Install with a flare-in installation tool and an arbor press.

Press these rounded head nuts into a closed-end hole or thick panel in applications where the back of the panel is inaccessible. A quarter-turn locks and releases access panels, doors, and covers.

Press these rounded head nuts into the backside of a panel in applications where you have access to both sides of the panel. A quarter-turn locks and releases access panels, doors, and covers.

These rounded head nuts can be riveted into thin panels for a flush fit. They can be mounted without spaces between the panels. A quarter-turn locks and releases access panels, doors, and covers.

These rounded head screws have a nut that clips onto the edge of a thin panel, allowing you to mount the screw near edges. A quarter-turn locks and releases access panels, doors, and covers.

Also known as clinch style captive nuts, press these nuts into a drilled or punched hole with an arbor press or similar pressure tool.

These nuts have good chemical resistance and may be mildly magnetic.

A flat hex head sits flush against the material surface for use in low-clearance applications.

These press-fit nuts have a zinc plating for corrosion resistance in wet environments.

Also known as broach style captive nuts, these metric nuts have good chemical resistance and may be mildly magnetic.

Use an arbor press or similar pressure tool to install these spring plungers into a panel.

Lock the nose in the retracted position by pulling the knob and rotating it 90°.

These steel studs are zinc plated to resist corrosion in wet environments.

With the end clinched in place, the prongs allow you to quickly snap a panel on and off these supports.

Secure the self-tapping female connection with a screw; the other end snaps snugly into a panel, yet can be released for repairs and upgrades.

Position, pivot, and align components. Also known as pilot pins and PEM® TP4, TPS, and MPP pins.