With an internal spring mechanism, these punches offer one-hand operation when marking hole centers.

Also known as center punches, strike these with a hammer to mark hole centers in metal and other materials.

Strike these Starrett punches with a hammer to mark hole centers in metal and other materials. Also known as center punches.

Ground to a sharper tip than other center-marking punches, these tools make the precision marks required for the intersection of lines and other detailed tasks. They're also known as prick punches.

Fit these through existing holes and mark the center of the hole in a second workpiece.

These sets come with three punches for use with a variety of hole sizes. Insert one into an existing hole and twist the handle to open the end of the punch. The point automatically centers once the punch has fit the hole size.

Also known as blind-hole spotters, these punches fit into closed-end holes and mark the center of a complementary hole.

Push down on the spring-loaded cone to center the punch in a variety of round and square hole sizes.

Also known as transfer screws, the punches in these sets can be used in any threaded hole to transfer the hole location. Use the handle to screw a punch into a hole.

The punches in these sets have a uniform shoulder height so you can quickly transfer multiple hole locations at once. Also known as transfer screws.

Locate and mark the centerline on rods, tubes, and pipes, lay out keyways, and establish angles for connections.