Fit these through existing holes and mark the center of the hole in a second workpiece.

Also known as blind-hole spotters, these punches fit into closed-end holes and mark the center of a complementary hole.

These sets come with three punches for use with a variety of hole sizes. Insert one into an existing hole and twist the handle to open the end of the punch. The point automatically centers once the punch has fit the hole size.

Push down on the spring-loaded cone to center the punch in a variety of round and square hole sizes.

Also known as transfer screws, the punches in these sets can be used in any threaded hole to transfer the hole location. Use the handle to screw a punch into a hole.

The punches in these sets have a uniform shoulder height so you can quickly transfer multiple hole locations at once. Also known as transfer screws.

Center your work by mounting these into your drill chuck or collet and lining up the pointer with the mark on the shaft.

Punch has two viewing lenses. One has a circle and dot and one has a crosshair to enable you to pinpoint the location where you need to punch. Replace the lens with one of the two included punches and strike it with a hammer to mark the hole center.

With an internal spring mechanism, these Starrett punches offer one-hand operation when marking hole centers.

Use the Starrett punches in these sets to mark hole centers in metal and other materials. Also known as center punches.

Ground to a sharper tip than other center-marking punches, these tools make the precision marks required for the intersection of lines and other detailed tasks. They're also known as prick punches.

A hardened body and point provide the extra strength and wear resistance necessary for continuous use on manual or CNC lathes.

Also known as bull-nose centers, these have a wide head to hold pipe and large-diameter tubing.

Made from hardened steel, these jaws have a long service life even when performing heavy machining such as roughing cuts.

No need to break down a collet set up when a workpiece doesn't fit a 5C collet. Install one of these lathe chuck adapters in your 5C collet chuck or holder and its three jaws will securely grasp the workpiece.

Hold machinable lathe chuck jaws in place during machining to make accurate cuts, ensuring the jaws will securely grip your workpiece.

The jaws move inward at the same time to consistently position your workpiece in the center of the vise.

Install these gauges onto the jaws of electronic, dial, and vernier calipers to measure the center-to-center distance between two holes.

Contains pin-loosening, pin-removal, and center-marking punches as well as chisels.