94 Products

Also known as Type II safety cans, these have two openings—one for filling, one for pouring. Safety cans are a safer choice than fuel cans for storing flammable liquids. They have a spring-loaded, self-closing lid; pressure-relief cap; flame arrester; and a vacuum-release valve for controlled pouring.

Color-coding typically indicates usage: red for gasoline, yellow for diesel, blue for kerosene, and green for other liquids.

Style B have a steel roll bar that protects the spout, handle, and trigger during transport.

Tip cans down for controlled dispensing, then swing them back to their upright position. These cans have a pressure-relief cap with built-in vacuum-release valve for controlled pouring.

Powder-coated steel can is for petroleum-based liquids.

Polyethylene plastic can is for chemicals and corrosives.

A self-closing faucet provides controlled, one-handed dispensing of flammable liquids. These safety cans also have a flame arrester and a self-closing pressure-relief cap.

Powder-coated steel cans are for petroleum-based liquids.

Polyethylene plastic cans are for chemicals and corrosives.

Stainless steel cans are corrosion resistant and often used with liquids such as acetone, ether, toluene, and xylene.

For technical drawings and 3-D models, click on a part number.

No need for separate spill-control pallets or trays—comply with EPA regulations for storing hazardous liquids with just one tank. These tanks have two walls, so if the primary compartment ruptures, the secondary one will contain the leak. It can hold 110% of the primary tank's volume and will also protect it from damage in case of impact.

Made of polyethylene, these tanks can store a broader range of chemicals than steel double-wall tanks. The plastic contains UV inhibitors so they can be used outside.

These tanks have a flat space on top where you can mount a metering pump. Because these tanks meet NSF/ANSI 61 for drinking water, you can meter chemicals stored in them into your drinking water system.

For technical drawings and 3-D models, click on a part number.

Provide extra protection for products that require double-wall containment, such as diesel and waste oil, solvents, and antifreeze. The tank's second wall forms a spill-control compartment that holds 110% of the primary compartment's storage capacity. They have an opening for venting in the primary compartment, an opening for leak detection in the secondary compartment, and two openings for emergency venting in the primary and secondary compartments.

For technical drawings and 3-D models, click on a part number.

These tanks are typically used for storing fuel and waste oil.

500-gal. capacity tank has nonslip steps and hand grips for easy access to the top of the tank.

For technical drawings and 3-D models, click on a part number.

These tanks collapse for easy storage and have a vent to relieve pressure.

Safely transport and store inert gas in these tanks.

Safely transport and store acetylene in these tanks.

Safely transport and store oxygen in this tank.

Safely transport and store propane gas in these tanks. The painted finish resists rust. POL/Acme (Type 1) valve has an internal POL connection, an external Acme connection that can be hand tightened, and an overfill prevention device.

Use propane in heating, thawing, and soldering applications. These cylinders cannot be sold to Canada due to local regulatory limits on carbon based fuels.

Propylene produces the highest flame temperature and is better than propane for brazing applications.

Use oxygen with other fuels to increase flame temperature.

Style C have a filter that strains out dirt and water, a valve to switch between filling and draining, and a flame arrester to protect against outside ignition. Rotate the hand pump to dispense fuel. The pump hose has a grounding strap.

Replace the propane tank on vehicles. Tanks come unfilled.