Also known as quick links, these links thread closed by hand or with a wrench.

Flat sides allow webbing and strapping to lay flat, so they won't slide and bunch.

The twisted shape of these links prevents loads from rotating or knotting.

Strike the prongs with a ball peen hammer and they expand to hold the connecting link together.

Drive the end through the eye using a ball peen hammer and then weld or flatten the extended end to close. These links are also known as cold shuts.

Also known as C-links, the notch in these links lets you slip additional links on or remove links quickly.

The flat side allows you to connect webbing and strapping, so they lay flat and resist bunching.

Hang, pull, and secure loads. These rings are good for general non-lifting applications.

Hammer the pin through the center to assemble these links. They’re also known as hammer locks and sling links.

The wide end of these links has more room for attachments than standard figure-eight links.

Providing better load distribution and alignment than single oblong links, these reduce wear in three and four leg slings.

Also known as master and sling links, a large inner diameter provides room to attach multiple connectors or legs on a sling.