Filter by
Strand Type
Roller Chain Trade Number
Chain Standard
System of Measurement
Chain Pitch Type
Specifications Met
Material
Chain Style
Link Type
Performance
Roller Chain Type
U.S.–Mexico–Canada Agreement (USMCA) Qualifying
Roller Width
Roller Diameter
Working Load
DFARS Specialty Metals
Export Control Classification Number (ECCN)
REACH
RoHS
Roller Chain and Links
 |
Chain |
 |
Connecting Links |
 |
Adding-and-Connecting Links |
 |
Pair this chain with sprockets to transmit power between rotating shafts. Like the chain on a bike, the side plates have a figure-eight shape that grips the sprockets without slipping.
Lubrication is key to smooth operation and long chain life. Routinely apply oil by hand or install an oil dispenser for continuous lubrication.
Corrosion-Resistant-Coated Steel—Combines the strength of steel with the corrosion resistance of stainless steel. The coating has been tested to withstand 500 hours of salt spray, so it holds up well in wet and outdoor conditions.
Connecting Link—Use a single link to join both ends of your chain. Start by removing the spring clip or cotter pin from the link’s side plate. Then, slide the link pins into the mating rollers at each end of your chain and snap the clip back on. Also known as master links.
Adding-and-Connecting Link—An all-in-one link for adding and connecting. It adds a half-pitch length at the roller end, allowing finer length adjustments than full-pitch links. The pin end connects to your chain—except for trade number 25, which requires a separate connecting link. Remove
the side plate to install. Also known as half links and offset links.
