These 18-8 stainless steel anchors have good chemical resistance.

Keep fixtures solidly in place—these anchors have two locking wedges that won't shake loose.

These 18-8 stainless steel anchors have good chemical resistance.

An open-end cap nut provides a finished appearance.

Bolts are beveled under the head for a flush finish in countersunk holes.

These 18-8 stainless steel anchors have good chemical resistance.

A zinc plating provides corrosion resistance in wet environments.

Install like a stud anchor—just thread the anchor, a nut, and a washer onto the end of a threaded rod, drive into a hole, and turn the nut to expand the base. Also known as rod anchors, they're often used with threaded rod to hang pipe and wiring.

Also known as double expansion anchors, these expand from both sides for full contact and a secure hold.

Also known as tap-in or uni-tap rivets, these anchors are barbed to resist pull out. Made from nylon, they're chemical resistant.

Use in applications requiring high strength.

Use with any type of sheet metal or wood screw.

18-8 stainless steel anchors have good chemical resistance.

18-8 stainless steel anchors have good chemical resistance.

For narrow holes and small cavities where toggle anchors won't fit.

Used with adhesive in bricks and hollow blocks, such as cinder blocks, these mesh tubes create a stronger hold for rods and studs than other anchors.

These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.

These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.

Attach the components of these sets onto a hammer drill to install tapping screws in concrete, block, and brick.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

Drill holes up to 1 1/2" in diameter.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

The SDS-Max shank has three deep slots and two shallow slots for use with SDS-Max-drive rotary hammers.