Conveyor guides direct and position material.

Bend these guides without any extra equipment to match the corners and curves in your conveyor.

Use these guides when positioning static-sensitive material such as electronic equipment.

A clamp on one end grips conveyor guides or rods.

These rods have a bracket on the base so they're ready to mount.

Use the hole at the end of these rods to attach sensors and accessories without clamps.

To make aligning multiple brackets during installation easy, these rods have 1/8” graduation marks. They also have a pivoting joint, so you can adjust the angle of your mount.

Clamps hold guide rails in place or join ends of a rail together.

Brackets mount to the frame of a conveyor to hold mounting rods.

Suspend trays, plates, and drip pans underneath a conveyor.

Separate products into distinct lanes with guides and nose plows.

Swap out, add, or adjust components on these mounts to get your conveyor guide exactly where you need it.

Position your sensor exactly where you need it for your conveyor setup.

Spacers increase the distance between a bracket and the conveyor frame.