Use these diamond-coated hollow bits for wet drilling of masonry, concrete, and rebar with a drilling rig.

These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

These hollow bits are diamond-tipped for long life and fast cutting speeds. Only for use in drill presses.

Use these inch size cutters with magnetic-base drills.

Use these metric cutters with magnetic-base drills.

The geometry of these cutters allows you to cut aligned holes in multiple sheets at one time.

The carbide teeth on these saws last up to twice as long as high-speed steel teeth.

These standard saws have high-speed steel teeth.

These saws have high-speed steel teeth.

With two adjustable blades, these saws cut a variety of hole sizes in ceilings, walls, floors, and other surfaces made of drywall, plaster, plastic, and wood. To block flying chips and collect dust, they have a clear debris shield.

The diamond-grit edge on these hole saws cuts more accurately, leaves a smoother finish, and lasts up to twice as long as carbide-grit-coated teeth.

These high-speed steel saws cuts through aluminum, brass, bronze, and steel.

Make clean, fast cuts in thin metal and plastic when you use one of these saws with an impact driver. The body widens at the top to prevent the saw from pushing through your workpiece.

An extra-thick steel body with carbide teeth can cut through stainless steel structural framing and electrical enclosures.

Use these saws with a drill press to cut a variety of hole sizes in sheet metal.

These kits have saws with high-speed steel teeth and a steel body.

The saws in these kits have carbide-grit-coated teeth that cut ceramic tile, fiberglass, masonry, plastic, and composites.