Designed to withstand impact in high-traffic areas, these stops have an anchor that mounts in a hole and sets with grout. Install them in concrete floors to protect walls from large doors in warehouses and manufacturing areas. Made of rubber, these stops are abrasion resistant. They're also nonmarring.

These stops have a metal stem and base for strength and durability. Use them to protect walls from doors in high-traffic applications. All have a rubber pad, which is abrasion resistant. Mount them with the included screws.

Remove the pin on your door's hinge, slide it through one of these stops, and then insert it back into the hinge to set and adjust the door's opening angle. Both stops have nonmarking rubber pads, which are abrasion resistant. Use the locking screw or threaded stud to make your adjustments.

Simply screw these bumpers into baseboards with the attached self-tapping wood screw to prevent doors from damaging walls. All of these stops have a nonmarking rubber pad, which is abrasion resistant.

Keep sliding doors and panels from damaging walls and door frames. Mount these stops with screws.

Press these silencers into a drilled hole in the door frame. Doors close firmly yet quietly with these silencers. They also eliminate the rattling of doors against their frames. Made of rubber, they are abrasion resistant. They require _1/8" of clearance between the door and the frame.

Simply adhere this silencer to the door frame—no need for an installation hole. Doors close firmly yet quietly with this silencer. It also eliminates the rattling of doors against their frames. Made of rubber, this silencer resists abrasion. It requires _1/8" of clearance between the door and the frame.

Protect door knobs and other hardware from damage caused by carts, dollies, and other equipment. Mount these bumpers on doors next to, above, below, or over the item you wish to protect. Install them with screws.