These steel screws are zinc plated to resist corrosion in wet environments.

These steel screws cut threads in drilled holes as they’re turned, so they require less driving torque and cause less stress on your material than thread forming screws.

A Torx drive has more points of contact than a Phillips drive, allowing you to apply extra force with less slippage or damage to the recess.

Made from 410 stainless steel, these screws are strong, wear resistant, and mildly chemical resistant.

The green color identifies these as grounding screws. They have a flange that provides a wide flat surface for making solid electrical connections.

These steel screws save you time and effort by drilling their own holes and fastening in a single operation.

With a drilling tip, these metric screws cut their own pilot hole and threads as you fasten them into material.

A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.

Cutting their own pilot hole and threads as you fasten them into material, these metric screws have a drilling tip.

These 18-8 stainless steel screws have a hardened steel drill point to penetrate steel and are coated to increase corrosion resistance.

18-8 stainless steel screws have good chemical resistance.

These steel screws are zinc plated to resist corrosion in wet environments.

By drilling their own holes and fastening in a single operation, these square-drive screws save time and effort. Made of 410 stainless steel, they're both stronger and more wear resistant than 18-8 stainless steel screws.

A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.

Made from 18-8 stainless steel, these screws have good chemical resistance.

One-third the weight of steel, aluminum screws resist corrosion in wet environments.

Beveled under the head for use in countersunk holes.

These screws have a free-rotating, permanently attached washer that remains stationary while tightening to prevent bunching while attaching tarps and other fabric to metal.

These steel screws are available with corrosion resistant finishes. A rubber-bonded washer compresses to form a watertight seal. They save you time and effort by drilling their own holes and fastening in a single operation.

These screws cut threads into drilled holes as they’re turned, so they require less driving torque and cause less stress on material than thread-forming screws.

18-8 stainless steel screws have good chemical resistance.

Because these steel screws cut threads into drilled holes as they’re turned, they require less driving torque and cause less stress on material than thread-forming screws. Also known as trim-head deck screws, they have a small flat head and slender shank to reduce the risk of splitting boards.

18-8 stainless steel screws have good chemical resistance.

A drill point powers through metal up to 0.105" thick.

Power through drywall and into metal studs up to 0.105" thick.