Cut left-hand external threads on bolts, studs, and rods.

Repair the broad, square threads on Acme threaded studs and rods. These dies are for general purpose Acme threads with a Class 2G thread fit.

A smaller width than standard hex dies lets you repair threads in tight spaces.

Clamp these dies around your workpiece, so you can start thread repair anywhere along the length of a bolt, stud, or rod. They're hex shaped for use with conventional wrenches.

Use a single set for many sizes of internal and external threads. All sets include tap and die wrenches.

Renew external threads in a wide range of sizes. The dies in these sets have a narrower width than standard dies, making them a good choice for thread repair in tight spots.

Repair rusted or damaged external threads in a variety of sizes.

The small size and spring-loaded jaw lets you make quick cuts with one hand.

Insulated handles protect against shock from accidental contact with live electrical circuits. These cutters are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Cut medium steel chain and hard steel bolts, rods, screws, rivets, nails, bars, wire, and rebar.

Slice through bolts and chain with low effort.

Also known as nippers, these cutters have wide, flat jaws that cut steel wire and bolts close to the surface.

An alternative to hacksaws and bandsaws, these cutters use leverage to cut rods cleanly in a single stroke.

Hydraulic-powered jaws cut bolts, wire rope, rods, and electrical cable with low effort and minimal material distortion.

Solid carbide provides more rigidity than carbide-tipped tools.

When cutting threads in nonferrous and nonmetallic materials, such as aluminum, copper, fiberglass, and plastic, diamond tips provide superior cutting performance.

Reduce tooling setup time—install the holder once and alternate between applications by switching out the bit.