Create holes for installing heavy duty industrial connectors. When the die and punch are pressed together, four centering mandrels in the die mark where to drill holes for the connector's assembly.

Use a wrench to cut DIN-size holes in steel up to 1/16" thick.

Create larger holes and make repeated punches with these drivers that supply 11 tons of force to the included hole punches.

Rotate the angled head of the driver up to 180° to fit it into tight spaces and supply eight tons of force to the hole punches.

Punch conduit up to size 1 1/4.

Slide thin sheets of material into the included die block then punch an inner and outer hole to create a shim or washer.

Attach two punch heads to the handle at the same time to punch a gasket or washer in a single strike.