The spring-clamp terminals on these blocks make wire installation faster than other types of terminals. Push wire into the spring clamp for a secure connection that withstands vibration and temperature changes. Add as many circuits as you need with these terminal blocks and accessories; blocks mount side-by-side on DIN 3 rail.

Blocks with fuse holder allow inline fuse wiring to protect components and wires from short-circuit damage.

Use blocks with disconnect tab for testing.

End covers fit on the open side of a block to prevent accidental contact with a live circuit.

End stops mount at the end of a group of blocks to prevent movement.

Adjacent jumpers connect terminals on adjacent blocks of the same width. Alternate jumpers connect terminals on two blocks of the same width, skipping a block in between.

Numbered marker cards include two of each number (1-50).

Note: Prices are 15% lower when you buy 25 or more of the same size.

For technical drawings and 3-D models, click on a part number.

Add as many circuits as you need with these terminal blocks and accessories. The terminal blocks clip onto DIN 2 rail. Terminal blocks, end covers, and end stops meet IP20 to protect connections from objects larger than 12.5 mm, such as fingers.

Spring-clamp terminals make wire installation faster than screw-clamp terminals. Push the wire into the spring clamp for a secure connection that withstands vibration.

Blocks with fuse holder allow inline fuse wiring to protect components and wires from short-circuit damage.

End covers fit on the open side of a block to prevent accidental contact with a live circuit.

End stops mount at the end of a group of blocks to prevent movement.

Jumpers connect terminals on adjacent blocks of the same width. Noninsulated jumpers can be cut to size.

For technical drawings and 3-D models, click on a part number.

Recessed terminals prevent accidental contact with a live circuit.

Blocks with screw terminals provide a more secure connection than blocks with grooved-clamp terminals. Use with ring terminals, spade terminals, or stripped wire; you can attach them without removing the screw.

Use blocks with grooved-clamp terminals with stripped wire. The grooved clamps hold the wire tight to prevent it from moving.

For technical drawings and 3-D models, click on a part number.

The spring-clamp terminals on these blocks make wire installation faster than other types of terminals. Push wire into the spring clamp for a secure connection that withstands vibration and temperature changes.

Use DIN rail adapters to mount blocks to DIN 3 rail. Two adapters per block are required, except the two-circuit blocks need only one adapter.

For technical drawings and 3-D models, click on a part number.

Mount to DIN rail for quick installation and removal. These distribution blocks take a high-current wire from your power source and connect it to one or more wires going to your electrical devices.

The current rating is based on NEC table 310-16 using 75° C copper wire.

Blocks with a quick-disconnect load connection allow you to connect an auxiliary device, such as a horn or light.

Blocks that meet IP20 protect connections from objects larger than 12.5 mm, such as fingers.

For technical drawings and 3-D models, click on a part number.