Clear All
    Pin Number
    Pin Number
    10
    System of Measurement
    System of Measurement
    Inch
    Head Type
    Head Type
    Threaded
    Large End Diameter
    Large End Diameter
    default
    0.706"
    Material
    Material
    Steel
    Stainless Steel
    Thread Size
    Thread Size
    Show
    Pin Type
    Pin Type
    Taper
    Small End Diameter
    Small End Diameter
    default
    0.581"
    0.602"
    0.612"
    0.623"
    0.633"
    0.644"
    End Shape
    End Shape
    Rounded
    Shaft Type
    Shaft Type
    Tapered
    Thread Length
    Thread Length
    7/8"
    Breaking Strength
    Breaking Strength
    46,500 lbs./sq. in.
    54,000 lbs./sq. in.
    End Type
    End Type
    Plain
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    Rate of Taper
    Rate of Taper
    1/4" per 12"
    Minimum Hardness
    Minimum Hardness
    Rockwell B85
    Rockwell B90
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Passivation
    Passivation
    Not Passivated
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    12 Products