Dremel-Compatible Sanding Bits

	Form Form

	Spiral-Wound Roll
	Shank-Mount Pad
	Bit

	Shape Shape

Straight

Tapered

	Grit Grit

	For Finish For Finish

Rough

Smooth

Extra Smooth

	Diameter Diameter

	Length Length

	For Use With For Use With

Grinders for Bits and Burs

Drills

Hand-Held Power Drills

Dremel Grinders for Bits and
Burs

	For Use On For Use On

	Abrasive Material Abrasive Material

Aluminum Oxide

Ceramic Alumina

Zirconia Alumina

	Maximum Speed Maximum Speed

Less than 10,000 rpm

10,000 to 19,999 rpm

20,000 to 29,999 rpm

30,000 rpm or greater

	Abrasive Backing Material Abrasive Backing Material

Fabric

Plastic

	Arbor Hole Arbor Hole

Unthreaded

Threaded

	DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense Acquisition Regulations Supplement)

DFARS Specialty Metals
COTS-Exempt

	For Holding For Holding

Sanding Pads for Internal
and Irregular Surfaces

Sanding Sleeves

	Shank Diameter Shank Diameter

1/8"

1/4"

	Mount Type Mount Type

Arbor

Shank

	Overall Width Overall Width

1 1/2"

	REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)

REACH Compliant

	Sanding Pad Style Sanding Pad Style

	Arbor Hole Thread Size Arbor Hole Thread Size

1/4"-20

8-32

	RoHS (Restriction of Hazardous Substances) RoHS (Restriction of Hazardous Substances)

RoHS Compliant

	Thickness Thickness

1/4"

1/2"

3/4"

	For Manufacturer Model Number For Manufacturer Model Number

134 Products

About Sanding Abrasives

Spiral-Wound Sanding Rolls

As the outer layer wears away, new abrasive is exposed.

Long-Life Spiral-Wound Sanding Rolls

The premium abrasive stays sharp longer.

Spiral-Wound Sanding Roll Assortments

Keep a convenient mix of spiral-wound sanding rolls on hand. As the outer layer wears away, new abrasive is exposed.

Spiral-Wound Sanding Rolls for
Stainless Steel and Hard Metals

Nylon Mesh Cushioned Sanding Pads
for Internal and Irregular Surfaces

The abrasive-embedded mesh construction gives you more control over sanding pressure, creating finer and more consistent finishes.

Sanding Pads for Internal and Irregular Surfaces

Sand inside pipes and tubes as well as on an angle to reach into corners and slots.

Replaceable-Cap Sanding Bits

Slip a cap onto the head of a shank and sand small, recessed, and hard-to-reach areas.

Sanding Sleeve Drums for
Dremel Hand-Held Power Tools

This drum is required to use a sanding sleeve with a Dremel grinder.

Arbors for Sanding Pads for
Internal and Irregular Surfaces

Also known as cross- and square-sanding pad shank adapters, these arbors are required to attach sanding pads for internal and irregular surfaces to hand-held drills and die grinders.