We will reply to your message within an hour.
More
Assortments include a selection of sanding sleeves to shape, debur, and sand edges and internal surfaces.
Shape, debur, and sand edges and internal surfaces.
The premium abrasive stays sharp longer.
The abrasive-embedded mesh construction gives you more control over sanding pressure, creating finer and more consistent finishes.
A coating prevents dust and debris from building up on the abrasive surface. These sleeves shape, deburr, and sand edges and internal surfaces.
The tungsten carbide abrasive is extremely durable.
Assortments include a variety of sanding drums and sleeves to shape, deburr, and sand edges and internal surfaces.
Flexible flaps reduce gouging while producing a uniform finish on flat and curved surfaces. They provide more control than a standard sanding sleeve but are more aggressive than a traditional flap wheel. As the flaps wear, new abrasive is exposed.
As the outer layer wears away, new abrasive is exposed.
Keep a convenient mix of spiral-wound sanding rolls on hand. As the outer layer wears away, new abrasive is exposed.
Slip a cap onto the head of a shank and sand small, recessed, and hard-to-reach areas.
Choose a bit with the same angle as your countersink to debur the inside of the hole.
Sand inside pipes and tubes as well as on an angle to reach into corners and slots.
Secure the shank into the collet or chuck of your tool.
Various sizes and grits of flap sanding wheels are included in these assortments. Secure the shank into the collet or chuck of your tool.
No tools required—twist the drum head by hand to tighten the sanding sleeve to the drum.
This drum is required to use a sanding sleeve with a Dremel grinder.
Slide a sanding sleeve on the drum and tighten the nut or screw to securely hold the sleeve.
Also known as cross- and square-sanding pad shank adapters, these arbors are required to attach sanding pads for internal and irregular surfaces to hand-held drills and die grinders.
The arbor’s shank attaches to hand-held drills and die grinders. Threads on the body hold the sanding roll in place.
Use flap wheels with a threaded stud in tools that accept a shank.
Attach cutoff wheels to a Dremel grinder.
Pair with Dremel rotary tools to securely grip bits and burs.
Shape and smooth wood, fiberglass, and rubber surfaces or remove rust from metal.
Sharpen, deburr, and grind metal surfaces.
Polish, deburr, and remove rust from metal surfaces such as tools, machine parts, and electrical contacts.
Convert your rotary tool into a plunge router to route circles, route freehand, and cut decorative edges, straight slots, and inlay work.
Screw these hangers onto your workbench.
Complete a wide range of cutting, grinding, and sanding tasks by pairing these accessories with your rotary tool.
Replace the brush and spring on your rotary tool.
The quick-change arbors in these kits allow you to easily swap accessories.
Turn Dremel rotary tools into miniature drill presses.
Cut holes, slots, and shapes in workpieces.
For engraving and carving, these kits contain a variety of Dremel-compatible bits and stones.