Made of aluminum oxide, these bits are well suited for use on most metals and materials that are not heat sensitive.

The abrasive grains in these bits are blended with rubber, which cushions during grinding to produce a smoother surface texture than other bits with similar grits.

Each set contains a selection of our most popular grinding bits.

The diamond abrasive in these bits is extremely hard and lasts longer than tungsten carbide. For longer tool life and improved finish, use a water- or oil-soluble mist or coolant.

Shape, debur, and sand edges and internal surfaces.

The premium abrasive stays sharp longer.

A coating prevents dust and debris from building up on the abrasive surface. These sleeves shape, deburr, and sand edges and internal surfaces.

The tungsten carbide abrasive is extremely durable.

Flexible flaps reduce gouging while producing a uniform finish on flat and curved surfaces. They provide more control than a standard sanding sleeve but are more aggressive than a traditional flap wheel. As the flaps wear, new abrasive is exposed.

Slip a cap onto the head of a shank and sand small, recessed, and hard-to-reach areas.

Keep a convenient mix of spiral-wound sanding rolls on hand. As the outer layer wears away, new abrasive is exposed.

The premium abrasive stays sharp longer.

Secure the shank into the collet or chuck of your tool.

Attach cutoff wheels to a Dremel grinder.

Also known as cross- and square-sanding pad shank adapters, these arbors are required to attach sanding pads for internal and irregular surfaces to hand-held drills and die grinders.

Thread rubber-cushioned grinding bits onto one of these arbors to use them in drills and die grinders.

This drum is required to use a sanding sleeve with a Dremel grinder.

Slide a sanding sleeve on the drum and tighten the nut or screw to securely hold the sleeve.

The silicon carbide abrasive cuts quickly with light pressure.

Polish small areas and hard-to-reach spots. Use in a drill or grinder for bits and burs.

A uniform density helps distribute abrasive grains evenly throughout these felt wheels for a more consistent surface polish.

Use these wheels to cut through metal such as aluminum, iron, stainless steel, and steel.

A ceramic alumina abrasive cuts through stainless steel.

Cut plastic, wood, and soft metal such as aluminum, brass, and copper.

The segmented edge on these blades is coated with diamond grit for cutting plastic.

The small brush face can access hard-to-reach spots to remove light-to-medium rust and stains and small burs.

Remove light-to-medium rust and stains and small burs with these flexible-bristle brushes.

Use on delicate surfaces.