Multiple outlining teeth bore clean, flat-bottom holes without chipping or splintering your surface—even when cutting across the grain. Also known as multispur bits.

Also known as spade bits, these have a centering point and two cutting edges for boring holes in hard and soft wood.

An open spiral-flute design clears chips quickly, so these bits can bore smooth, deep holes through construction lumber, railroad ties, and utility poles. Also known as pole or ship auger bits.

The screw point draws the bit in, quickly boring holes without applying pressure.

Unlike traditional wire-installing drill bits, you do not need to strip the end of the wire when using one of these bits. After drilling, insert the wire into the bit's hollow shaft and pull through the hole.

The built-in guide has a beveled tip that fits into countersunk holes in hardware, such as hinges and latches, to center the bit.

Bore smooth-finish, flat bottom holes in soft wood, veneer, and laminates. Also known as Forstner bits.

Also known as spade bits, these have a centering point and two cutting edges for boring holes in hard and soft wood.

For use on wood and plastic.

Drill, countersink, and drive screws without switching three separate bits in and out of your power tool.

Use with plastic and wood.

For jobbers’ and brad-point drill bits.

Convert standard jobbers’ and brad-point drill bits into counterboring drill bits that drill and counterbore at the same time.