Lock these brackets together with a pin or a bolt. They are often used on marine docks.

Connect wood 2×4s to posts and other flat surfaces.

Also known as angle brackets.

The two-piece design accommodates a wide range of panel thicknesses.

A built-in level makes it easy to align panels.

These brackets come in one piece that can be cut-to-size with a hacksaw.

Position proximity, photoelectric, and light beam sensors and switches.

Half the weight of steel, this aluminum framing resists corrosion in wet environments.

Attach sensors, tubes, and other components to T-slotted framing rails and structures.

Build test fixtures, prototypes, and other small structures with this miniature version of T-slotted framing and fittings.

Securely fasten strut channel to the floor.

Close off openings in structures while allowing air to pass through.

Thread one of these plates onto your ram and use the four mounting holes to secure it in place.

Add a flat mounting surface to to a screw jack to support loads.

Mount workpieces in precisely located holes for repeatable setups.

Use these plates to ensure accurate right angles and hold workpieces and fixtures perpendicular to a machine table.

Also known as vacuum chucks, these plates secure thin and flexible parts that can’t be held with vises or clamps for milling, drilling, routing, and finishing operations. Connect the system to your shop’s compressed air supply and it's ready to use.

Harder and stronger than our other aluminum perforated sheets, these sheets have greater wear resistance.

These sheets are stronger than our other plastic perforated sheets for greater impact and abrasion resistance.

Brass is softer and easier to form compared to other metals.

These are our most flexible plastic perforated sheets.

Use thesee sheets for machine guards and protective panels in noncorrosive environments.

Install these mounts on machines without feet.