Clear All
    Collet Type
    Collet Type
    ER-20
    For Collet Type
    For Collet Type
    ER-20
    System of Measurement
    System of Measurement
    Inch
    For Holding
    For Holding
    Collets
    Drill Bits
    End Mills
    Reamers
    Face Type
    Face Type
    Round
    Overall Length
    Overall Length
    1.22"
    For Use With
    For Use With
    Milling Machines
    Material
    Material
    Steel
    Maximum Body Diameter
    Maximum Body Diameter
    0.83"
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Approximate Diameter Compression
    Approximate Diameter
    Compression
    1/16"
    Shank Type
    Shank Type
    R8 Taper
    CAT 40 Taper
    Projection
    Projection
    2"
    2 1/2"
    4"
    6"
    9"
    Mounting Location
    Mounting Location
    Bench Top
    For Number of Collets
    For Number of Collets
    36
    Mounting Slot Length
    Mounting Slot Length
    1 1/16"
    Mounting Slot Width
    Mounting Slot Width
    1/4"
    Number of Mounting Slots
    Number of Mounting Slots
    2
    Overall Height
    Overall Height
    1 3/8"
    Overall Depth
    Overall Depth
    7 7/32"
    Overall Width
    Overall Width
    9 1/8"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    23 Products

    ER-20 Collets

    Collet Chucks

    ER-20 Collet Stands