Made of fiberglass, these enclosures are lightweight and won’t rust, but still shield push-button controls from water, dirt, and oil. They have holes already drilled to standard button sizes, saving you time. Because they’re lighter in weight than metal enclosures, they’re also easier to mount. You can machine these enclosures to add additional cord grips, control panels, and other components. Yet, they won’t dent or break if hit by dropped tools or debris. All of these enclosures hold up in very hot and cold environments—from metal forges to freezers. When installed outdoors, they won’t discolor or break down from UV rays.

Enclosures with a mounting bracket don’t require you to drill holes through their walls when mounting them to a surface, preserving their NEMA rating.

Add a panel to the inside of these enclosures to mount internal equipment without drilling holes and maintain the enclosure’s NEMA rating. You can remove the panel to easily assemble electronics outside of the enclosure.

For technical drawings and 3-D models, click on a part number.

Able to withstand periodic submersion in water, these enclosures offer our highest level of protection from liquids. They’re made of fiberglass to resist impact and corrosion from solvents, alkalis, and mild acids. Rated NEMA 6P and 12, they protect the components inside from dirt, washdowns, corrosion, splashing or seeping oil/coolant, and water submersion.

All of these enclosures meet American and Canadian safety standards. Enclosures rated UL 94 5VA will stop burning within a minute if they catch fire, and won’t spread fire by dripping.

Enclosures with a quick-release or twist latch offer easy access without screws or clamps to unfasten.

Raised covers provide additional depth.

Panels are for mounting components inside enclosures.

For technical drawings and 3-D models, click on a part number.

Holes in the cover allow easy installation of push buttons, switches, and indicating lights. These enclosures offer our highest level of protection from liquids, including periodic submersion in water, when used with equivalently rated components. They are rated NEMA 6P and 12 for protection from dirt, washdowns, corrosion, oil/coolant dripping, and water submersion.

For technical drawings and 3-D models, click on a part number.

Bury these enclosures in the ground or in concrete to protect and maintain access to electrical service and other underground utilities. They withstand freeze/thaw conditions and have an open bottom for water drainage. They also withstand occasional vehicular traffic, are nonconductive, and are impact and corrosion resistant. You can stack multiple enclosures in deep holes with one cover (sold separately).

Covers include two bolts for attaching to enclosure.

Cover hooks make it easier to lift a cover.

For technical drawings and 3-D models, click on a part number.

Route wires, cables, and tubing along T-slotted rails.

For technical drawings and 3-D models, click on a part number.