Twice as strong as our standard reinforced strapping tape for extra-heavy loads. Fiberglass fibers run along the length.

For added reinforcement, fiberglass fibers run the length and width of this strapping tape. It forms stronger bonds than our other reinforced tape.

Reinforced with fiberglass, this tape is flexible yet resists tearing. Use it for sealing and patching insulation and duct.

When exposed to moisture, this resin-coated fiberglass tape becomes rock-hard in about 30 minutes. Use it for rigid, waterproof repairs.

Aluminum foil is laminated to a tough fiberglass cloth to form a high-strength, reflective tape that resists temperatures up to 500° F. Use it for flame-spray masking and wire harness heat shielding.

Use this slippery PTFE-coated tape for a smooth release on heat sealers and molds.

This tape discharges minor amounts of surface static electricity and resists static buildup.

Made with fiberglass for durability and abrasion resistance, this tape also withstands high temperatures.

Press this adhesive-backed plastic tape into place for an immediate light-duty seal.

Assortments include two 4" × 4" patches and a 6" × 6" patch.

Made of fiberglass, these seals are woven tighter than High-Temperature Ultra-Conformable Slotted Edge Seals for increased durability. They resist grease, oil, hydraulic fluid, and solvents and can withstand temperatures up to 1000° F.

The PTFE coating on these fiberglass seals is slippery, so they are easier than the other seals to press fit into oven, furnace, and boiler doors. These seals resist steam, most refrigerants, salts, and grease. They can withstand temperatures up to 500° F.

A silicone-coated fiberglass cover sheds sparks and molten metal splash. These seals resist steam, most refrigerants, salts, and grease. They can withstand temperatures up to 450° F.

One layer of fiberglass cloth is inserted between two layers of silicone rubber to give these sheets and strips the strength to stand up to high stress and flex. Use them as flange gaskets and anywhere heavy compression would squeeze nonreinforced silicone rubber out of place.

Commonly used as curtains and in sealing applications.

The PTFE coating makes these fiberglass sheets nonstick and chemical resistant.

The 3M VHB adhesive on these rolls offers a strong hold that can replace rivets, spot welds, and other permanent fasteners.