Tighten the set screws to fasten these couplings to your shaft. Set screws bite into the shaft to hold the couplings in place.

Each hub includes a set screw, which bites into your shaft to hold the coupling in place.

Able to handle high twisting forces as well as misalignment, these couplings are good for high-performance servomotor applications.

Connect shafts and ball screws to high-speed servomotors and stepper motors—these shaft couplings handle four times more speed than standard servomotor couplings.

An acetal plastic spacer at the center of these couplings insulates bearings, encoders, and other shaft components from stray electric current. Use them with servomotors, which sometimes generate current that travels down the shaft and can damage circuit boards, interfere with readings, and cause wear on bearing raceways.

The thick split spider on these couplings takes on twice as much torque as standard split spiders, while a set screw holds the hubs in place on your shaft. Also known as jaw couplings, use them to connect motors to pumps, mixers, and other high-torque equipment.

Each hub includes a set screw, which bites into your shaft to hold the coupling in place.

Customize the bore of these flexible couplings to align uncommon shaft sizes as well as shafts that have become undersized from wear or oversized from coatings.

Safely connect slightly misaligned shafts near food lines—the spider on these couplings contains metal, so it’ll trigger a metal detector if a piece frays off and contaminates your batch.

A strip of flexible spring steel wraps around the teeth of both hubs to absorb sharp, momentary load increases that can come from motor startups, emergency braking, or sudden impact with hard objects.

With a rugged roller-chain design, these couplings provide excellent torque and angular misalignment capacities.

Use these gear-shaped couplings for high-speed and high-torque applications.

Magnetic force transfers torque from one half of these couplings to the other; there’s no contact between the parts, so they won’t wear. Couplings compensate for angular and parallel misalignment.

Use these U-joints in wet environments to connect and transfer torque between two shafts.

Ideal for wet environments, these U-Joints are stainless steel, so they have good corrosion resistance while also balancing strength. They have a heat- and water-resistant silicone cover (also known as a boot or bellows) to keep lubricant in and contaminants out.

Made to meet strict military standards for material and construction, these stainless steel U-joints also balance strength with good corrosion resistance. Customize their bores until they fit your shafts.

Drill the bores to create custom U-joints that meet strict military standards for material and construction.

Choose these U-joints for applications that run continuously in wet environments.

To keep your shafts moving in sync, the flexible spring on these joints makes the output shaft move at the same rate as the input shaft.

Ideal for use in assemblies that change frequently, these U-joints have clamping screws that can be quickly loosened when you need to move them.

Since these U-joints have zero backlash (no play), there’s no motion lost when your shafts change direction, so machines move smoothly with more accurate, repeatable motion. As double U-joints, they connect and transfer torque between two shafts that are either parallel to each other or are misaligned at an angle.

Connect and transfer torque between two shafts that are either parallel to each other or are misaligned at an angle.

With zero backlash (no play), there’s no motion lost when these torque limiters transfer torque, so machines move smoothly with accurate and repeatable motion. They protect your machinery if there is a jam, emergency stop, or other overload by cutting off torque when a maximum torque is reached.

Protect your machinery if there is a jam, emergency stop, or other overload by cutting off torque between shafts when a maximum torque is reached.