Run cable and tubing in the tightest spaces with channel that is one-quarter the height and one-half the width of regular strut channel.

With welded ends, these short lengths of strut channel provide a finished look when mounting clamps and accessories to machines and surfaces.

Slide the strut channel into the tube for telescoping length adjustments.

This welded, one-piece strut channel combines two strut channels side-to-side.

A spring plus serrated grooves that grip the lip of the channel provide a more secure hold than standard strut channel nuts.

Push these nuts into place rather than threading them onto a fastener.

In addition to serrated grooves for gripping the lip of the channel, these nuts have wings for easy positioning.

Quickly attach these nuts by twisting them closed at any point along a threaded rod.

Insert these nuts into the long open side of strut channel and twist to secure. A built-in washer enables one-handed installation.

Serrated grooves grip the lip of the channel.

Use with hex nuts to connect threaded rod.

Add hardware to strut channel without having to hold the washer in place or reach inside the channel.

Push these brackets into strut channel and tighten the included cam screws for a partially concealed connection.

Securely fasten strut channel to the floor.

Mount a length of strut channel between the ends of a beam to run cable and conduit along the beam without drilling.

Cover rough ends of strut channel.

Position two strut channels at a 30° to 60° angle, then tighten the bolt to secure.

Slip these hangers onto the lip of top-opening strut channel to attach chain, wire rope, pipe, and threaded rod.

Connect T-slotted rails and reinforce joints for structural stability.

Stay organized with hooks, bin boxes, shelves, and tool holders that work with T-slotted framing.

Add panels to T-slotted framing to create machine guards, strip doors, and welding curtains.

Integrate collaborative robots into T-slotted framing systems with these components.

Pivots provide smooth motion at the junction between two T-slotted rails.

Route wires, cables, and tubing along T-slotted rails.

Illuminate workstations, enclosures, and machines.

Add mounting feet and casters to T-slotted framing structures to level equipment, anchor legs to the floor, or add mobility.

Seal T-slots, rail ends, and gaps between rails to keep out dust, debris, and other contaminants.

Mount components to these load-rated bearings and track rollers to add linear motion along T-slotted rails.

Slide drawers, panels, and doors with these tracks and rollers.

Mount these bull's eye levels to workstation and table frames made of T-slotted framing for easy leveling in all directions on the horizontal plane.

Use hinges to add doors, lids, and machine guards to T-slotted framing.

Half the weight of steel, this aluminum framing resists corrosion in wet environments.

Fittings come in two pieces to wrap around rails, so you can quickly modify existing structures without disassembling. Use clamp-on framing and fittings to form temporary partitions, modular conveyors, and workstations.

Close off openings in structures while allowing air to pass through.

In addition to being lightweight and strong, this plastic framing is nonconductive with good resistance to chemicals and salt water.

Half the weight of steel, this aluminum framing resists corrosion in wet environments.

Reduce noise caused by HVAC systems. These sturdy rubber supports isolate vibration caused by heat pumps and air conditioning units, resulting in a quieter facility. When used on roofs, they also keep components above puddled water, which can cause damage.