Combine components to create a railing. They are sized to fit together and mount on floors and walls.

Use coupling and urethane structural adhesives (not included) to connect two lengths of rail. When installed, the coupling is completely concealed by the rail.

Make stairs and ramps safe and accessible for all with these ADA-compliant railings. They’re made of high-strength galvanized steel for durability and corrosion resistance, even outdoors. These railings are paintable and can be cut to length.

Ground-mount railings are supported by posts that mount to your staircase or ramp. They’re inline with the posts to give you space to navigate in narrow areas. Add an additional post for extra support if your railing extends beyond six ft.

Wall-mount railings are supported by brackets that mount to your wall. They’re commonly used for stairs or ramps that don’t have space for mounting posts. Because they’re offset with the wall, a portion of the grab bar juts out for easy access. Add another wall bracket for more support if your railing is longer than six ft.

For technical drawings and 3-D models, click on a part number.

Combine bases, rails, gates, and toeboards to create a barrier customized to your needs. When properly installed in a U-shape, these items meet OSHA 29 CFR 1910.29 requirements for fall protection systems. Rails, bases, and toeboards also meet OSHA 29 CFR 1926.502 requirements for fall protection systems. Base is weighted to allow installation without drilling holes.

Rails can pivot in 45° increments.

Gate can be mounted to swing open to the left or right.

To protect the work surface from scuffs and scratches, use nonskid pads.

Use rail-to-base connecting pins to secure the rails to the bases.

For technical drawings and 3-D models, click on a part number.

Weighted bases allow you to install these railings without drilling holes.

Railings can pivot in 45° increments. When properly installed, they meet OSHA 29 CFR 1910.29 and OSHA 29 CFR 1926.502 requirements when making a U-shape.

To protect the work surface from scuffs and scratches, use nonskid pads.

For technical drawings and 3-D models, click on a part number.

Slip these posts and rails together for a complete railing—no fittings required. Use an add-on railing to create a longer length.

All railings come unassembled so you can cut them to length as needed.

For technical drawings and 3-D models, click on a part number.

Connect rails and posts with included slip-on fittings to quickly assemble a railing. They come unassembled, so you can cut them to length as needed.

Steel railings have a yellow powder coating for good visibility.

Aluminum railings are corrosion-resistant in wet environments.

Use add-on railings to extend the length of your railing. They include rails, fittings, and a post.

Select your own fittings, rails, and posts to create custom configurations. Rails and posts do not come with fittings.

Tees are used to connect rails and posts. Pass-through tees slide over a rail so you can add a post in the center. Joining tees connect the ends of two rails to a post.

Adjustable-angle fittings have a moveable joint, so you can position your rails at any angle. Tighten set screws to secure them to rails.

When properly installed, they meet OSHA 29 CFR 1910.29 requirements for guardrail systems.

For technical drawings and 3-D models, click on a part number.