The driver supplies eight tons of force to the hole punches in this set to make straight punches.

Rotate the angled head of the driver up to 180° to fit it into tight spaces and supply eight tons of force to the hole punches.

The included hydraulic driver allows you to punch conduit up to size 2.

Attach two punch heads to the handle at the same time to punch a gasket or washer in a single strike.

Quickly switch between inner and outer punches to create washers faster than with standard sets.

Slide thin sheets of material into the included die block then punch an inner and outer hole to create a shim or washer.

Use these sets to knock out pins and rivets that have already been loosened.

The punches in these sets have a knurled handle, which offers a more secure grip than standard punches. Use them to knock out pins and rivets that have already been loosened.

Loosen pins and rivets before removal.

Contains pin-loosening, pin-removal, and center-marking punches as well as chisels.

Fit the punches in these sets through existing holes and mark the center of the hole in a second workpiece.

These sets come with three punches for use with a variety of hole sizes. Insert one into an existing hole and twist the handle to open the end of the punch. The point automatically centers once the punch has fit the hole size.

The punches in these sets have a uniform shoulder height so you can quickly transfer multiple hole locations at once. Also known as transfer screws.

Also known as center punches, strike these with a hammer to mark hole centers in metal and other materials.