No need for adhesive—this tape fuses to itself for a permanent seal and stretches to fit virtually any form. Also known as cold shrink tape.

At only 0.0025" thick, this tape combines conformability with durability and abrasion resistance.

Quickly conduct heat away from electronic components. Kapton® polyimide gives this tape excellent electrical isolation.

Twice as thick as our standard antistatic electrical tape, this tape is made of abrasion-resistant aramid and antistatic PTFE.

Use this tape to modify printed circuit boards, shield components, and prototype wiring-board layout and design.

This polyester tape has a woven mesh edge that conducts electricity. Use it to shield cables and electronic components from EMI (electromagnetic interference).

Cover holes, fastener heads, and small areas with these discs.

In addition to handling temperatures up to 500° F, this fiberglass tape is tough enough for abrasive applications such as sand blasting.

Cover small spots and holes while paint stripping and electroplating, or use as a moisture and dust barrier. These aluminum foil discs are flexible and conform to irregular shapes.

For outdoor painting jobs, this plastic tape stands up to the elements. The high-tack adhesive works on rough exterior surfaces, such as stucco and masonry.

Use these convenient cut shapes to mask holes, fastener heads, and small areas while soldering.

This tape reflects intense heat to protect sensitive components.

Protect impact-prone surfaces from scratches, chips, and abrasion with this thick, conformable tape.

Seal out light to mask LEDs and prevent backlight bleed on LCD monitors with this opaque polyester tape.

Use this PTFE-coated tape as a liner in chutes and to protect molds.

Also known as skived tape, this low-friction tape stretches to conform to irregular surfaces.

Low-Friction Tape Shapes Made with Teflon® PTFE.

A strong, thick layer of Teflon® PTFE makes this tape tougher than standard Low-Friction Tape Made with Teflon® PTFE.

Highly resistant to impact, tearing, and corrosive chemicals, use FEP tape to line chutes and hoppers and to cover shelves in laboratories.

Protect small parts with these slippery UHMW rings, discs, and squares.

Reduce noise and vibration in chutes, bins, and similar delivery systems with this UHMW-faced foam tape.

Often referred to as Rulon and bearing tape, this self-lubricating PTFE tape provides better abrasion and wear resistance than our standard slippery PTFE tape.

For easy identification, this tape is printed with flexible duct standard UL 181A-P or UL 181B-FX.

Create strong, permanent bonds that can replace mechanical fasteners.

Prevent the spread of fire while sealing, cushioning, and damping vibration. This tape has adhesive on both sides.

Wrap this tape around carbon fiber and other composite parts, then heat to 150° F. Tape shrinks to squeeze out air bubbles and apply pressure so parts cure without voids.

Use this glossy tape to seal seams and repair vinyl material such as banners.

Only 0.0019" thick, so spliced film and paper easily pass through machinery without breaking.