Attach two punch heads to the handle at the same time to punch a gasket or washer in a single strike.

This set includes all six sizes of our individually sold hand-driven hole punches plus a tool to remove punched out material. Turn the handle of these punches while pushing down to punch holes in cork and rubber. Also known as cork borers, these tools have precision-ground edges that can be sharpened.

The handle and punch are one complete tool.

This set includes common ID and OD sizes to create gaskets and washers in two strikes.

About half the size of a standard portable lever-operated punch, these punches can fit in your toolbox. The lever handle provides extra punching force to quickly punch through metal. The punches have an adjustable throat to reach varying depths from the edge of your material. Switch out the included punch and die to create holes of different sizes.

Note: As your punch size increases, the thickness of steel these tools can cut decreases.

Slide thin sheets of material into the included die block then punch an inner and outer hole to create a shim or washer.

For accurate punching of inner and outer holes, these sets come with pilots that attach to the outer hole punch.

Quickly switch between inner and outer punches to create washers faster than with standard sets.

A throat depth more than double those of standard bench-mount lever-operated punches allows this tool to reach further past the edge of material. It is often used to make holes in signs for fasteners. The included punch and die are replaceable.

Note: As your punch size increases, the thickness of steel this tool can cut decreases.