Made from unhardened aluminum or steel, machine these jaws to fit the contours and curves of your workpiece.

Significantly cut down on jaw changeover time—this two-part system lets you swap out jaws in less than 30 seconds. Mount the jaw plates to the vise and slide the dovetailed jaw stock in and out of the plates.

The V‐shaped recess holds round material securely for machining.

Replace worn flat and V jaws.

These V-shaped liners hold large round material.

Place over the jaws and tighten the screws to securely attach liners.

The head tilts and locks in place to hold work at an angle.

Two vise heads tilt and rotate 360°, locking in place to hold work at any angle.

Hold tiny workpieces in these compact vises.

A bright yellow vise body stands out on the shop floor.

The movable jaw can be repositioned to extend the jaw opening. Pull out the entire sliding section and insert it on the opposite side of the vise.

Made of 304 stainless steel to stand up to washdown environments, such as food and beverage production, these are the most corrosion-resistant vises we offer.

Quickly install and remove the clamp-on base from a benchtop.

Steel jaws secure round workpieces such as pipe, tubing, and conduit.

Machine these jaws to fit the curves and edges of your unique workpiece for a tighter hold and more stability than standard hardened jaws.

Also known as scroll chucks, these are self centering—all three jaws move in unison, centering the workpiece as they close.

When a job calls for a 5C collet, save time by using an adapter instead of removing your lathe chuck.

No need to break down a collet set up when a workpiece doesn't fit a 5C collet. Install one of these lathe chuck adapters in your 5C collet chuck or holder and its three jaws will securely grasp the workpiece.

Grip bearings, gears, and wheels from the outside edge to pull them off a shaft.

Sets include various sizes of quick-hold external grip pullers. Each puller has a cage around the jaws that keeps them in place for a quick job of gripping bearings and pulleys.

Complete with a locking storage box, use the pullers in this set to tackle a wide variety of pulling jobs—use pullers to grip objects from the outside or the inside.

Grip objects on the outside or inside to tackle both types of pulling jobs.

The jaws grip most round surfaces, even highly polished objects. Push down on the wrench and pull the handle toward you—the jaws will tighten around the workpiece.

Hold fine wire and filament.

Grip paper, film, and thin plastic.

Combine these grippers with your gripping fingers to lift and move items in pick-and-place applications.

These grippers pick up a product and turn it 90° or 180° before releasing.

Unlike air-powered grippers, which leak air, these electric grippers won’t release dirt or particulates, making them good for pick-and-place assembly, packaging, and finishing jobs in labs, electronics plants, and other clean environments. Often used with mobile robots, all have a servomotor that opens and closes the grippers with equal force.

Build a complete robot gripping tool using these grippers, fingers, and robot tool mounts.

The integral arbor is more rigid for greater accuracy than a drill chuck used with a separate arbor.

Made of stainless steel, these chucks are rust and corrosion resistant.

A ball-bearing design provides increased gripping force to keep bits from slipping, which allows these chucks to take on high-torque drilling applications. Also known as super chucks.

Also known as positive-drive chucks, these chucks mount directly onto a straight spindle for use in high-torque applications.

These steel rod ends are machined to SAE standards.

In addition to offering superior chemical resistance, these lightweight, fiber-reinforced nylon rod ends also reduce noise and vibration.

Make quick adjustments to these rod ends by inserting and releasing the clevis pins without the need to bend them into place.

Attach these nuts to rods, pipes, and tubes to make pivoting and hinge movements where misalignment is not a concern.