Adjust the horizontal screw to hold workpieces of varying sizes in precise positions. These stops thread into a hole in your fixture or machinery or into a T-slot nut for use on a machine table.

Swivel Pads—Swivel pads move in all directions to make maximum contact with angled and uneven workpieces.

Slide these low-profile supports under a workpiece to provide support and reduce vibration. The slot in the center of these supports allows for positioning at any angle before bolting them down to a machine table or fixture. Turn the handle to extend the spring-loaded plunger and lock it in place. For additional height adjustment, thread a screw or support button (sold separately) into the plunger.

Create a secure, vibration-resistant connection between your D-sub cord and panel. Commonly found on the back of PC monitors, these jack screws prevent cords from accidentally disconnecting. Install them through untapped holes with a nut and washers, or screw them into tapped holes. The female-threaded end accepts the thumb screws on your D-sub cord.