These junction blocks have threaded holes that allow air or fluid to flow at a 90° angle through the block. Use them to organize and separate multiple lines in your system.

Designed for ultra-clean environments, these manifolds are cleaned, dried, and vacuum sealed in plastic to prevent dirt and moisture from contaminating the inside. Use them to distribute air or fluid to multiple locations from a single supply source. Also known as headers.

Unlike other manifolds, which have an inlet on either end, these have one inlet on the opposite side from the outlets. This design allows air or fluid to follow a straight path, improving flow through your system. Also known as headers.

When you’re short on vertical space, these manifolds are a good fit—they have outlets on the side instead of on top, so they have a lower profile than rectangular manifolds. Use them to distribute air or fluid to five locations from a single supply source.

Mount these manifolds on the end of a hose line to distribute air, water, or hydraulic fluid to three locations from a single supply source.

With an easy-to-cut hose and push-to-connect fittings, you can install a compressed air line system in just a few hours.

A single row of terminals fits in narrow spaces.

Recessed screw terminals prevent you from accidentally connecting two circuits with a screwdriver or other tool, causing a short.

Best for equipment requiring regular servicing, these blocks disconnect without having to remove any wiring thanks to their plug-and-socket design. Their recessed screws prevent shorts by reducing the risk you’ll connect two circuits with a screwdriver or other tool.

No need to tighten or loosen any screws—these terminals lock your wiring in place with spring clamps.

Visually confirm your circuits are working as expected. These terminal blocks have integrated LEDs that indicate if your circuits are powered or not, helping you troubleshoot issues.

Rated IP20, these blocks have recessed terminals to prevent accidental contact with live circuits.

Save time when wiring connections in a junction box; these blocks come already installed in an enclosure.

Blocks mount in a cutout and have terminals on both sides.

Stack multiple ring or spade terminals on the stud terminal; the current flows through the stacked terminals.

Protect connections against corrosion.These bars are tin-plated copper and have stainless steel terminals.

With the help of distribution blocks, you can take a high-current wire from your power source and connect it to one or more electrical devices.

Connect RTD wire leads to conduit or instrumentation.