Use a wrench to cut DIN-size holes in steel up to 1/16" thick.

Create holes for installing heavy duty industrial connectors. When the die and punch are pressed together, four centering mandrels in the die mark where to drill holes for the connector's assembly.

Create larger holes and make repeated punches with these drivers that supply 11 tons of force to the included hole punches.

Rotate the angled head of the driver up to 180° to fit it into tight spaces and supply eight tons of force to the hole punches.

The included hydraulic driver allows you to punch conduit up to size 2.

Use these one-piece tools to make round holes up to 1 3/4" dia.

These standard saws have high-speed steel teeth.

Quickly connect these saws to your drill or drill press with the built-in arbor.

The carbide-tipped teeth on these saws last up to twice as long as high-speed steel teeth.

The carbide teeth on these steel saws cut hard metal such as steel, stainless steel, cast iron, and titanium.

The diamond-grit edge on these hole saws cuts more accurately, leaves a smoother finish, and lasts up to twice as long as carbide-grit-coated teeth.

These high-speed steel saws cuts through aluminum, brass, bronze, and steel.

An extra-thick steel body with carbide teeth can cut through stainless steel structural framing and electrical enclosures.

These saws reduce friction and prevent material buildup when cutting fiberglass and plastic.

Use these saws with a drill press to cut a variety of hole sizes in sheet metal.

The saws in these kits have carbide-tipped teeth, so they last up to twice as long as saws with high-speed steel teeth.

Lower cutting depths than standard hole saws make these saws less likely to rip or tear while making smooth, burr-free cuts in sheets.

A circular groove quickly centers plug in unused holes and knockouts.

Sized for knockouts and conduit openings.

Sized for knockouts and conduit openings.

Close 2" square holes in the floor of your enclosure with these adhesive plugs.

Close off unused threaded holes.

Made of steel, these are our most durable plugs for panels. Tapered prongs snap into the hole to securely hold them in place.

Vents in the top allow air circulation and permit heat and fumes to escape. These plugs have tapered prongs that snap into the hole to securely hold them in place.

Vents in the top allow air circulation and permit heat and fumes to escape. All of these plugs have wings that expand against the sides of the hole to lock them in place.

The wings on these plugs expand against the sides of a hole to form a liquid-tight seal. Pierce the plugs with round wire, cable, or tubing and they function as a grommet to create insulated holes.

Switch hole saws without using adapters or special tools.

A thick shoulder makes these pins more rigid than standard ejector pins.

A 60° beveled head fits into a countersunk hole.