System of Measurement
    System of Measurement
    Inch
    Metric
    Diameter
    Diameter
    3"
    4"
    5"
    6"
    8"
    10"
    12"
    15"
    For Maximum Workpiece OD
    For Maximum Workpiece OD
    2 15/32"
    3 5/32"
    3.54"
    5.51"
    7.87"
    Material
    Material
    Steel
    Aluminum
    Brass
    Grip Style
    Grip Style
    Inside
    Outside
    Center Through-Hole Diameter
    Center Through-Hole Diameter
    5/8"
    7/8"
    1.28"
    1.78"
    2.37"
    For Maximum Workpiece ID
    For Maximum Workpiece ID
    2 3/4"
    3 35/64"
    3.74"
    5.91"
    7.09"
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    For Lathe Chuck Diameter
    For Lathe Chuck Diameter
    4"
    5"
    6"
    8"
    10"
    12"
    15"
    18"
    21"
    24"
    5"-8"
    6"-10"
    8"-12"
    Collet Type
    Collet Type
    5CER-16
    3J16C
    ER-11ER-32
    100-TG
    For Minimum Workpiece OD
    For Minimum Workpiece OD
    5/64"
    0.08"
    0.31"
    0.39"
    For Minimum Workpiece ID
    For Minimum Workpiece ID
    63/64"
    1 3/16"
    1.42"
    2.17"
    TIR (Total Indicated Runout) Accuracy
    TIR (Total Indicated
    Runout) Accuracy
    0.0005"
    0.0008"
    0.0011"
    0.0015"
    0.0025"
    0.0031"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    403 Products