Replace clamps, screws, seats, and slotted pins in carbide insert holders.

These tools come with carbide inserts installed. When one edge of the insert dulls, rotate it to use a sharp edge.

Pair these holders with a threading insert or a grooving insert to make cuts on the outside of a workpiece.

Replace worn or missing clamps and clamp screws in high-performance carbide insert holders for threading and grooving.

These tools come with one high-speed steel insert for use on steel and stainless steel and one high-speed steel insert for use on softer materials, such as aluminum and brass. When one point of an insert dulls, rotate it to use a sharp point.

These holders conform to ANSI standards.

Deliver coolant through the holder to keep workpieces cool while boring tough materials, such as steel, stainless steel, and nickel-based alloys.

These sets have a variety of indexable boring insert holders with carbide inserts and a wood storage stand. When one edge of a tool's insert dulls, rotate it to use a sharp edge to enlarge existing holes to precise diameters.

Insert boring tools into a 45° or 90° slot at either end of the holder.

Reduce tooling setup time—install the holder once and alternate between applications by switching out the bit.

A V-groove enables these holders to grip round-shank as well as square-shank tools.

Two slide-in dovetail mounts on the tool posts allow you to quickly change from one tool holder to another.

A built-in drill chuck allows quick installation of drill bits, taps, and other round- or hex-shank tools into a quick-change tool post.

Mount any tool with a Morse taper shank to a quick-change tool post.